BERETTA CIAO AT 25 CSI CONDENSING BOILER COMPLETE WITH METHANE FUME EXHAUST KIT - NEW ErP

nb: in the absence of the ciao at, the NEW CIAO AT 25 LN LOW NOX model will be sent

BERETTA CIAO AT 25 CSI CONDENSING BOILER COMPLETE WITH SMOKE EXHAUST KIT - NEW ErP

---

• Product code: 20113788

Characteristics:

• Energy efficiency in heating: B
• Healthcare energy efficiency: A
• Sanitary load profile: XL
• Nominal heat input: 25 kW
• Electrical power: 129 W
• Supply voltage/frequency: 230/50 Volt/Hz
• Electrical protection degree: X5D ip
• Dimensions HxWxD: 780 x 400 x 338; 40 kg
• Gas version available: METHANE

Warm-up exercise:

• Maximum pressure and temperatures: 3/90 bar/°C
• Heating temperature selection range: 40/80 °C
• Pump: pump head available for the system: 266 m/bar
• Expansion tank capacity: 8 l

Healthcare Exercise:

• Maximum pressure: 6 bar
• Minimum pressure: 0.15 bar
• Quantity of hot water with ∆t=25°C: 14.3 l/min
• Minimum domestic water flow rate: 2 l/min
• Domestic hot water temperature selection range: 37 - 60 °C

---

Beretta CIAO AT

Hi AT, ideal for replacement in systems with radiators. Ciao AT is the innovative condensing boiler specifically designed by Beretta for traditional high temperature systems (radiators and radiators). The boiler is equipped with heat recovery on the fumes and combustion in a sealed chamber; this allows for very high performance in terms of efficiency and therefore significant energy savings.

High performance and reduced consumption In the Ciao AT boiler the water from the primary circuit passes through an additional exchanger, this allows energy to be recovered that would otherwise be wasted. This process allows you to recover latent heat and therefore further increase the performance of the boiler. The energy saving offered by a boiler is greater the higher its efficiency: Ciao AT therefore allows you to reduce gas consumption compared to a boiler without the additional exchanger.

Management: The electronic panel is the interface for managing the boiler. Simple and intuitive, it allows you to adjust the boiler parameters and activate the numerous functions. The liquid crystal display provides information on the status of the device and diagnostic codes. By turning the knobs you can easily and intuitively set the temperature of the heating water and domestic hot water. The panel integrates the Friendly Climate System function.

Ciao AT technology uses the condensing exchanger which recovers the latent heat of the fumes, the same principle used by condensing boilers. The exchanger, located at the top left, is connected directly to the fan which pushes the fumes inside before they are finally expelled. The difference in flue gas temperature between the ~140°C inlet and the ~65°C outlet of the condensing exchanger is indicative of the amount of heat recovered from them.

The return from the system first passes through the condensing exchanger which recovers the heat from the fumes, and then passes through the primary exchanger, where it receives the remaining heat in order to reach the required delivery temperature. The water therefore recovers part of the heat from the fumes, which would otherwise be expelled into the atmosphere, thus giving rise to less waste and consequently greater savings for the user.

Outdoor installation: Ciao AT is designed to also be installed outdoors in partially protected places thanks to the dedicated accessories (lower cover kit and upper cover kit) and the board's antifreeze protection up to 0 °C. In colder temperature conditions it is possible to extend the protection down to -10 °C using the specific antifreeze heater kit with which the lower cover is necessary.

Up to 17 meters of Ø 60 ducting with the Ciao AT boiler: With Ciao AT it is possible to conveniently duct even the most "difficult" flues thanks to the approval for Ø 60mm flue pipe which is added to the traditional Ø 80 mm duct flue pipe. The main 60mm flue pipes are available in the Beretta price list, while the boiler manuals provide maximum length indications, which differ depending on the boiler power.

TECHNICAL FEATURES:

• Specific for systems with radiators and radiators (high temperature)
• Post condensing exchanger in aluminum alloy
• Possibility of outdoor installation with antifreeze heater kit (optional)
• IPX5D electrical protection degree
• Environmental Self Regulation System (SARA)
• Low consumption circulator 6 m (EEI≤0.20)
• Hydraulic fittings cover (optional)
• Condensate collection neutralizer drawer kit (optional)
• Template, hydraulic fittings, gas and sanitary taps (optional)
• For gas transformation, contact authorized Beretta Technical Assistance Centers

---

Product Warranty
All products for sale on our site are new and packaged. The warranty on this item is 24 months from the date of purchase.

• peso: 35.0 kg
• classe energetica produzione acs: A
• classe energetica riscaldamento: B
• costospedizionecad: IT25;AD113;AT73;BE75;BG88;HR89;DK125;EE122;FR94;DE63;LV94;LT88;LU59;NL68;PT82;CZ66;SK73;SI74;ES75;SE131;HU56;CH135;
• gas: Methane
• marca: Beretta
• metri quadri : 150
• modello: CALD_1908
• potenza in kw: 25
• potenza nominale: 25
• superficie riscaldabile mq: 150